Size of Tech Deck Inverted Kingpin Screws


#1

Hey…anyone have the size of the screws? I found some 1.6 x 3.5 x 3mm on Microsfasteners but I don’t have a tool to measure them.

Anyone have a *caliper at home? Could you tell me the widght/length/height of the screws you have? I

Here is the link to the screws I was going to purchase
http://www.microfasteners.com/mspps1603-m1.6-x-.35-x-3mm-pan-head-machine-screws-phillips-stainless.html

I use to get them from Sponsor Me Tape but he doesn’t sell them anymore.


#2

I don’t have a micrometer but I have a caliper.

I don’t have Sponsor Me Tape screw but have Dynamic ones.

I measured them to be 1.50mm in Major Diameter, 7.25mm in length.

Hope it helps!


#3

Thank you! Corrected for caliper haha mixed those up. Have you tried the dynamic screws in TD Baseplates? You just pop-out the kingpin with a hammer and screw them in if you haven’t tried it before.


#4

Yeah, I have them on TD baseplates right now with 2KR hangers! It works pretty good and lower the kingpin on the 2KR trucks so it doesn’t stick out as far! :ok_hand:


#5

Did you purchase those screws and did they work for the TD base?